This kit contains everything you need to braid the cables inside your case ! After removing power connections, you can expand the braid over your cables, pull it tight , and then seal using either the included cable ties or heat shrink material.

Kit Includes:
3 metres of 3mm Braid
3 metres of 6mm Braid
1.5 metres of 9mm Braid
1.5 metres of 12mm Braid
12 Short Green Tie Wraps
30cm of 9mm Green Heatshrink Tubing
30cm of 18mm Green Heatshrink Tubing
15cm of 24mm Green Heatshrink Tubing

Mount a Black Ice II (Pro, Stealth GTor Xtreme) to the bottom of the Coolermaster Stacker.

* Made from Plexiglass
*Uses existing case hole and monting holes
*Easy to add the Fans and Radiators
*Complete with all mounting hardware and fitting instructions

Details:
• Small neck Funnel ideal for filling up your Water Reservoir

Spare Reservoir Holder for reservoirs 50mm diameter - Black

Now Available

Detailed Description:
For you guys looking for an easy way to monitor your water temps on your 1/2" water cooling system. Lightweight. The probe comes with untailed wires so it can be spliced into a digital display. Uses a standard 10k ohm thermistor -50 - 110 Deg C (320.2 - .7579 kohms)

Simple but very effective shroud that can be added to any 120mm fan having the effect of lifting the fan 15mm away from the radiator which not only drastically reduces noise but also eliminates the dead spot created by the fan which aids in better cooling to the radiator.

This In-Line thermosensor consists of a G1/4 inch thread, whereby a sensor is integrated. This sensor can be screwed in everywhere where a G1/4 " thread is free and thus the desired temperature can be read out at each fan CONTROLLER or display. Range of application would be the Cape Coolplex, Cape Bullseye or Repack Cooling Slot in. The sensor is accurate up to 0,3K.

It is made entirely of brass and nickel-plated.

Plexy Flow Meter with built in Water Filter
Compatible with G1/4" hose fittings
Barbs Included
Available in either 1/2" - 3/8" or 8mm Hose Tail from the drop down menu above.

Gives a clear indication of flow, and helps to clean your system from foreign bodies

A standard grade thread seal tape, of nominal thickness 0.075mm and density 0.4-0.5 g/cc, manufactured from 100% pure, virgin P.T.F.E. and containing less than 0.1% residual lubricant. Ideal for BSP fittings and suitable for use on hot and cold water systems.

A simple and easy way to fill your system. Just fill the syring with coolant and dispense into the fillport or reservoir. No mess, No fuss!

Each syringe can hold 60cc of coolant